On Wednesday 26 April 2017 04:41 PM, Adam Ford wrote:
On Wed, Apr 26, 2017 at 3:07 AM, Lokesh Vutla lokeshvutla@ti.com wrote:
Signed-off-by: Lokesh Vutla lokeshvutla@ti.com
Changes since v1:
- Update base addresses for MMC0 and MMC1
board/ti/am335x/board.c | 32 ++++++++++++++++++++++++++++++++ 1 file changed, 32 insertions(+)
diff --git a/board/ti/am335x/board.c b/board/ti/am335x/board.c index 3e842d3187..6786229680 100644 --- a/board/ti/am335x/board.c +++ b/board/ti/am335x/board.c @@ -9,6 +9,7 @@ */
#include <common.h> +#include <dm.h> #include <errno.h> #include <spl.h> #include <serial.h> @@ -26,6 +27,7 @@ #include <asm/emif.h> #include <asm/gpio.h> #include <asm/omap_sec_common.h> +#include <asm/omap_mmc.h> #include <i2c.h> #include <miiphy.h> #include <cpsw.h> @@ -892,3 +894,33 @@ void board_fit_image_post_process(void **p_image, size_t *p_size) secure_boot_verify_image(p_image, p_size); } #endif
+#if !CONFIG_IS_ENABLED(OF_CONTROL) +static const struct omap_hsmmc_plat am335x_mmc0_platdata = {
.base_addr = (struct hsmmc *)OMAP_HSMMC1_BASE,.cfg.host_caps = MMC_MODE_HS_52MHz | MMC_MODE_HS | MMC_MODE_4BIT,.cfg.f_min = 400000,.cfg.f_max = 52000000,.cfg.voltages = MMC_VDD_32_33 | MMC_VDD_33_34 | MMC_VDD_165_195,.cfg.b_max = CONFIG_SYS_MMC_MAX_BLK_COUNT,+};
Do you need to address the offset factor here if you're going to rebase from my series? My series removed the offset from struct hsmmc
OMAP_HSMMC1_BASE includes the offset. This is currently being used in driver as well for non-DM cases.
Thanks and regards, Lokesh