--- Wolfgang Denk wd@denx.de wrote:
In message 926455.96023.qm@web7701.mail.in.yahoo.com you wrote:
i am getting the following error while i tried to save the environment data.....why not i can save?????
I2C: ready DRAM: 16 MB FLASH: 4 MB *** Warning - bad CRC, using default environment
In: serial Out: serial Err: serial Net: No ethernet found.
Type "run flash_nfs" to mount root filesystem over NFS
Hit any key to stop autoboot: 0 => => saveenv Saving Environment to Flash... Error: cannot span across banks when they are mapped in reverse order Error: cannot span across banks when they are mapped in reverse order Protected 37 sectors =>
Thanks, Raj.
I tried to use the CFI driver by adding the CFI
macros
in the .h file. But the size of my flash is 2MB,
but
it shows 4MB.
So you misconfigured something...
I have one doubt, in the board .h file we specify
the
sectore size. what size i must give the sector
size in
board .h file.
The CFI driver will auto-detect the sector sizes. You must confuse something here.. Which exact #define are you talking about?
Best regards,
Wolfgang Denk
-- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd@denx.de "Have you lived in this village all your life?" "No, not yet."
Try the revolutionary next-gen Yahoo! Mail. Go to http://mrd.mail.yahoo.com/dc/landing