By now exynos_dw_mmc driver was relying on the correct CIU clock frequency being set on driver init. But dw_mmc core is actually trying to change CIU clock rate dynamically, on init and in set_ios() callback, which it's requesting via host->get_mmc_clk() callback (the name is misleading: although it's called "get_mmc_clk()", it can actually request both get and set operations). Implement setting the requested rate for CIU clock in Exynos driver to achieve the correct dw_mmc core driver operation at all times. DDR mode requires the clock to be twice as fast (when 8 bit bus is used), so handle this too, to make DDR function properly.
This change makes the eMMC throughput on E850-96 board twice as fast. That's because "clock-frequency" is set to 800 MHz in E850-96 device tree, but for DDR52 mode it should be 416 MHz (and TRM states it should be 400 MHz for DDR50/8bit mode). The dw_mmc core is requesting 52 MHz bus_hz for DDR52 mode, and DDR+8bit mode means it should be x2 fast, so:
f_ciu = 2 * ciu_div * f_bus = 2 * 4 * 52e6 = 416 MHz,
where f_ciu - freq of clock fed to DW MMC block from CMU (SDCLKIN), Hz f_bus - freq of clock fed to the card (CCLKIN), Hz ciu_div - value of internal divider (in DW MMC block).
Another way to work that around would be overriding the "clock-frequency" property in corresponding dts. But setting the clock frequency dynamically as it's done here looks much neater.
This implementation follows what's done in Linux kernel dw_mmc-exynos driver in .set_ios() callback for MMC_TIMING_MMC_DDR52 case.
Signed-off-by: Sam Protsenko semen.protsenko@linaro.org --- drivers/mmc/exynos_dw_mmc.c | 10 ++++++++++ 1 file changed, 10 insertions(+)
diff --git a/drivers/mmc/exynos_dw_mmc.c b/drivers/mmc/exynos_dw_mmc.c index d3708ecb6407..938fd51a2ac6 100644 --- a/drivers/mmc/exynos_dw_mmc.c +++ b/drivers/mmc/exynos_dw_mmc.c @@ -170,7 +170,17 @@ unsigned int exynos_dwmci_get_clk(struct dwmci_host *host, uint freq) u8 clk_div; int err;
+ /* Should be double rate for DDR mode */ + if (host->mmc->selected_mode == MMC_DDR_52 && host->mmc->bus_width == 8) + freq *= 2; + clk_div = exynos_dwmmc_get_ciu_div(host); + err = exynos_dwmmc_set_sclk(host, freq * clk_div); + if (err) { + printf("DWMMC%d: failed to set clock rate (%d); " + "continue anyway\n", host->dev_index, err); + } + err = exynos_dwmmc_get_sclk(host, &sclk); if (err) { printf("DWMMC%d: failed to get clock rate (%d)\n",