Hi Qianyu,
On 25 March 2016 at 03:34, Qianyu Gong qianyu.gong@nxp.com wrote:
Hi Simon,
I think I’m not very clear with this code in common/cmd_sf.c:
“
# ifdef CONFIG_DM_SPI_FLASH
/* Remove the old device, otherwise probe will just be a nop */ ret = spi_find_bus_and_cs(bus, cs, &bus_dev, &new); if (!ret) { device_remove(new); device_unbind(new); }”
I may understand the remove but why need to unbind the device?
This is because otherwise 'sf probe' would be a nop if the device already existed. The spi_flash_probe_bus_cs() call will simply return the existing device. If something has changed on the bus, it would be ignored.
The unbind would cause a series of free operations on the device list, correct?
Yes
Then if I probe a flash twice, at the second time the driver model will create
a new flash named ‘spi_flash@xx:xx’ using default settings because it doesn’t
find such a device in the device list and never probes it from the board’s fdt again.
Yes.
=> dm tree
Class Probed Name
root [ + ] root_driver
simple_bus [ + ] `-- soc
spi [ + ] |-- dspi@2100000
spi_flash [ ] | |-- n25q128a
spi_flash [ + ] | |-- spi_flash@1:1
spi_flash [ + ] | `-- spi_flash@1:2
Fortunately the default SPI mode set by U-Boot is SPI_MODE_3 so it doesn’t cause
issues on our boards. But if an SPI flash which only supports SPI_MODE_0 is used,
I think it wouldn’t work properly from the second probe.
Sorry if there is something wrong with my understandings.
Just because I found my flash’s name was changed to spi-flash@xx:xx in dm tree
after several probes, I began to read something about driver model.J
Yes I think removing the unbind would be OK, except that we need a way to show the messages at the end of spi_flash_scan().
Probably these messages should move out of the uclass and into a separate call. We could add a function like spi_flash_show(struct udevice *dev) and call it from do_spi_flash_probe() and perhaps saveenv().
Regards, Simon