Re: [U-Boot-Users] R: Booting with attached BDI but not alone (onlyICTRL remained in BDI cfg)

Hello!

DI BACCO ANTONIO - technolabs schrieb:

I verified that SRESET on the BDM connector is pulled up (on the schematic). I tried to pull up it with a wire but it doesn't work.

Have you used a voltage meter or oscilloscope to check the voltage level? Have you measured the resistance between SRESET and GND and between SRESET and supply? Have you checked if your processor pin is connected? Probably either the pull-up resistor isn't mounted or your PCB is defective.

With best regards Andreas Schweigstill