On 01/24/2012 04:21 PM, Simon Glass wrote:
This adds clock references to the USB part of the device tree for U-Boot.
The USB timing information may vary between boards sometimes, but for now we hard-code it in C. This is because all current T2x boards use the same values, we will deal with T3x later and we first need to agree on the format for this timing information in the fdt and may in fact decide that it has no place there.
The patch below does more than what's covered by this description...
Signed-off-by: Simon Glass sjg@chromium.org
Changes in v5:
- Add dr_mode property to control host/device/otg mode
- Add nvidia,has-legacy-mode property per review comments
- Change device tree comment style from // to /* */
arch/arm/dts/tegra20.dtsi | 7 +++++++ 1 files changed, 7 insertions(+), 0 deletions(-)
diff --git a/arch/arm/dts/tegra20.dtsi b/arch/arm/dts/tegra20.dtsi index ec75747..b2e3a40 100644 --- a/arch/arm/dts/tegra20.dtsi +++ b/arch/arm/dts/tegra20.dtsi @@ -176,6 +176,9 @@ reg = <0xc5000000 0x4000>; interrupts = < 52 >; phy_type = "utmi";
clocks = <&periph_clk 22>; /* PERIPH_ID_USBD */dr_mode = "otg";
The dr_mode value is board-specific, so should be in tegra-seaboard.dts not tegra20.dtsi.
For example, on true Seaboard, perhaps USB3 could operate in "otg" mode since it's an external port, whereas on Springbank, USB3 is hard-wired to a keyboard controller, so should be marked "host" mode only.
Related, I assume that any port marked as "otg" needs to have a VBUS GPIO defined so that it can be turned off in device mode, or is VBUS controlled by some other mechanism in some cases? Given that, I /think/ you can't actually mark USB3 as "otg" or "device" on Seaboard since there's no VBUS GPIO.