Re: [U-Boot] No prompt on mx25pdk boot

20 Oct 2011


      Hi Hugo,
On Thu, Oct 20, 2011 at 2:04 PM, Hugo Holgersson
hugoh@student.chalmers.se wrote:
...
Dear readers,
I have problems running U-Boot on my i.MX 25 PDK board.
I have tried two methods:
(A)
git clone git://www.denx.de/git/u-boot-imx.git master
nano board/freescale/mx25pdk/imximage.cfg  # change to BOOT_FROM nand
make CROSS_COMPILE=arm-none-linux-gnueabi- mx25pdk_config
make CROSS_COMPILE=arm-none-linux-gnueabi- u-boot.imx
The u-boot.imx is flashed using FreeScale AVK to address 0x400 in NAND. This image does not work (no UART output).
I have only tested booting MX25PDK from the SD card. Does this method
work for you?
Regards,
Fabio Estevam