We are switching to a model where our board file can directly fail probing of serial devices when they're not usable, so remove the current runtime hack we have.
Signed-off-by: Alexander Graf agraf@suse.de --- board/raspberrypi/rpi/rpi.c | 43 ------------------------------------------- 1 file changed, 43 deletions(-)
diff --git a/board/raspberrypi/rpi/rpi.c b/board/raspberrypi/rpi/rpi.c index c8924d4362..177f4af265 100644 --- a/board/raspberrypi/rpi/rpi.c +++ b/board/raspberrypi/rpi/rpi.c @@ -420,54 +420,11 @@ static void get_board_rev(void) printf("RPI %s (0x%x)\n", model->name, revision); }
-#ifndef CONFIG_PL01X_SERIAL -static bool rpi_is_serial_active(void) -{ - int serial_gpio = 15; - struct udevice *dev; - - /* - * The RPi3 disables the mini uart by default. The easiest way to find - * out whether it is available is to check if the RX pin is muxed. - */ - - if (uclass_first_device(UCLASS_PINCTRL, &dev) || !dev) - return true; - - if (pinctrl_get_gpio_mux(dev, 0, serial_gpio) != BCM2835_GPIO_ALT5) - return false; - - return true; -} - -/* Disable mini-UART I/O if it's not pinmuxed to our pins. - * The firmware only enables it if explicitly done in config.txt: enable_uart=1 - */ -static void rpi_disable_inactive_uart(void) -{ - struct udevice *dev; - struct bcm283x_mu_serial_platdata *plat; - - if (uclass_get_device_by_driver(UCLASS_SERIAL, - DM_GET_DRIVER(serial_bcm283x_mu), - &dev) || !dev) - return; - - if (!rpi_is_serial_active()) { - plat = dev_get_platdata(dev); - plat->disabled = true; - } -} -#endif - int board_init(void) { #ifdef CONFIG_HW_WATCHDOG hw_watchdog_init(); #endif -#ifndef CONFIG_PL01X_SERIAL - rpi_disable_inactive_uart(); -#endif
get_board_rev();