Hi Stefan,
I assigned the ethaddr as 192.168.13.246 and after that i run the command "saveenv " and reset the board. I got the following Net: ppc_4xx_eth0. once i get the shell prompt i assign the ipaddr as 192.168.13.241 and after that i run the command "saveenv" and reset the board. Now i tried to ping my Host PC which has the IP address as 192.168.13.240, i am getting the following error.....I am not able to ping the host IP. Can you please show some way to come of this issue..... => ping 192.168.13.240 Trying ppc_4xx_eth0 PHY speed read failed, assuming 10bT PHY duplex read failed, assuming half duplex ENET Speed is 10 Mbps - HALF duplex connection Using ppc_4xx_eth0 device sending ARP for c0a80df0 ARP broadcast 1 ARP broadcast 2 ping failed; host 192.168.13.240 is not alive => Regards, Shami...
Stefan Roese sr@denx.de wrote: On Wednesday 19 December 2007, shami Allam wrote:
I am working on the 405GP custome board. I am able to bringup the SDRAM,Flash,I2c and serail on the board. But while trying to bringup the ethernet i am getting the following error. "No Ethernet found". On my board there is "DP83848I" PHY chip.
This message gets printed when you don't define the "ethaddr" environement address. So set this variable to a valid value and save the environment and reset the board. Then you should see one eth-interface.
Best regards, Stefan
===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office@denx.de =====================================================================
--------------------------------- Get the freedom to save as many mails as you wish. Click here to know how.