This chip is on the board but handling should be done via firmware not via Linux driver. Changing status property to keep it in the tree to describe it instead of removing this node completely.
Signed-off-by: Michal Simek michal.simek@xilinx.com ---
arch/arm/dts/zynqmp-zcu100-revC.dts | 1 + 1 file changed, 1 insertion(+)
diff --git a/arch/arm/dts/zynqmp-zcu100-revC.dts b/arch/arm/dts/zynqmp-zcu100-revC.dts index 2fffe177b589..05491e9bbc0c 100644 --- a/arch/arm/dts/zynqmp-zcu100-revC.dts +++ b/arch/arm/dts/zynqmp-zcu100-revC.dts @@ -104,6 +104,7 @@
ltc2954: ltc2954 { /* U7 */ compatible = "lltc,ltc2954", "lltc,ltc2952"; + status = "disabled"; trigger-gpios = <&gpio 26 GPIO_ACTIVE_LOW>; /* INT line - input */ /* If there is HW watchdog on mezzanine this signal should be connected there */ watchdog-gpios = <&gpio 35 GPIO_ACTIVE_HIGH>; /* MIO on PAD */