21 Aug
2012
21 Aug
'12
8:05 a.m.
On 20/08/2012 22:25, Fabio Estevam wrote:
Hi Stefano,
On Mon, Aug 20, 2012 at 4:42 PM, stefano babic sbabic@denx.de wrote:
With the flea3 I have made some clean-up, making the lowLevel_init.S essential. Same changes were not reported back to the mx35pdk. I am going also to put in a common place the functions to setup the DDR controller ( board_setup_sdram_bank() in the flea3 directory). This should allow to factorize some other code, reducing the lowlevel_init.S.
Maybe even better would be to convert the init from lowlevel_init.S into C code, like was done on mx31.
It is much easier to debug/maintain C code then assemby.
Yes, agree.
Regards, Stefano
--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic@denx.de
=====================================================================