On Thursday, August 21, 2014 at 06:12:09 PM, Fabio Estevam wrote:
When testing the FEC driver on a mx6solox we noticed that the TDAR bit gets always cleared prior then the READY bit is set in the last BD, which causes FEC transmission to fail.
As explained by Ye Li:
"The TDAR bit is set when the descriptors are all out from TX ring, but the descriptor properly is in transmitting not READY. These are two signals, and in Ic simulation, we found the TDAR always clear prior than the READY bit of last BD. In mx6solox, we use a latest version of FEC IP. It looks the intrinsic behave of TDAR bit is changed in this FEC version, not any bug in mx6sx."
Fix this by polling the READY bit of BD after the TDAR polling, which covers the mx6solox case and does not harm for the other SoCs.
Signed-off-by: Fabio Estevam fabio.estevam@freescale.com
Changes since v2:
- Poll FEC_TBD_READY after polling TDAR
drivers/net/fec_mxc.c | 14 ++++++++++++-- 1 file changed, 12 insertions(+), 2 deletions(-)
diff --git a/drivers/net/fec_mxc.c b/drivers/net/fec_mxc.c index 56178d4..3050e58 100644 --- a/drivers/net/fec_mxc.c +++ b/drivers/net/fec_mxc.c @@ -719,12 +719,22 @@ static int fec_send(struct eth_device *dev, void *packet, int length) break; }
- if (!timeout) {
ret = -EINVAL;goto out;- }
- timeout = FEC_XFER_TIMEOUT;
- while (--timeout) {
if (!(readw(&fec->tbd_base[fec->tbd_index].status) &
FEC_TBD_READY))
This will never work, because you never invalidate the memory over the DMA descriptor here.
break;- }
- if (!timeout) ret = -EINVAL;
+out: invalidate_dcache_range(addr, addr + size);
And here you invalidate it for no reason ;-)
if (readw(&fec->tbd_base[fec->tbd_index].status) & FEC_TBD_READY)
ret = -EINVAL;debug("fec_send: status 0x%x index %d ret %i\n", readw(&fec->tbd_base[fec->tbd_index].status),
Best regards, Marek Vasut