1 Feb
2024
1 Feb
'24
5:19 p.m.
Hi Jesse,
On 01/02/24 16:00, Jesse Taube wrote:
Add documentation for imxrt1170-evk.
Signed-off-by: Jesse Taube Mr.Bossman075@gmail.com
looks good to me
Reviewed-by: Giulio Benetti giulio.benetti@benettiengineering.com
Best regards
--
Giulio Benetti
CEO&CTO@Benetti Engineering sas
> ---
> doc/board/nxp/imxrt1170-evk.rst | 42 +++++++++++++++++++++++++++++++++
> 1 file changed, 42 insertions(+)
> create mode 100644 doc/board/nxp/imxrt1170-evk.rst
>
> diff --git a/doc/board/nxp/imxrt1170-evk.rst b/doc/board/nxp/imxrt1170-evk.rst
> new file mode 100644
> index 0000000000..4acccdcc93
> --- /dev/null
> +++ b/doc/board/nxp/imxrt1170-evk.rst
> @@ -0,0 +1,42 @@
> +.. SPDX-License-Identifier: GPL-2.0+
> +
> +imxrt1170-evk
> +=============
> +
> +How to use U-Boot on NXP i.MXRT1170 EVK
> +---------------------------------------
> +
> +- Build U-Boot for i.MXRT1170 EVK:
> +
> +.. code-block:: bash
> +
> + $ make mrproper
> + $ make imxrt1170-evk_defconfig
> + $ make
> +
> +This will generate the SPL image called SPL and the u-boot.img.
> +
> +- Flash the SPL image into the micro SD card:
> +
> +.. code-block:: bash
> +
> + $sudo dd if=SPL of=/dev/sdX bs=1k seek=1 conv=notrunc; sync
> +
> +- Flash the u-boot.img image into the micro SD card:
> +
> +.. code-block:: bash
> +
> + $sudo dd if=u-boot.img of=/dev/sdX bs=1k seek=128 conv=notrunc; sync
> +
> +- Jumper settings::
> +
> + SW1: 1 0 1 0
> + SW2: 0 0 0 0 0 0 0 0 1 0 0 0
> +
> +where 0 means bottom position and 1 means top position (from the
> +switch label numbers reference).
> +
> +- Connect the USB cable between the EVK and the PC for the console.
> + The USB console connector is the one close the ethernet connector
> +
> +- Insert the micro SD card in the board, power it up and U-Boot messages should come up.