After this change it would be possible to use 'mtd' command to get access to XEA's SPI-NOR partitions by name (e.g. SPL), not by offsets.
To enable this feature the CONFIG_SPI_FLASH_MTD needs to be defined in the Kconfig, not in xea.h.
=> mtd list => mtd read spl-boot-data1 ${loadaddr} 0x0 4 => md.l ${loadaddr} 1
Signed-off-by: Lukasz Majewski lukma@denx.de ---
(no changes since v1)
configs/imx28_xea_defconfig | 4 ++-- include/configs/xea.h | 4 ---- 2 files changed, 2 insertions(+), 6 deletions(-)
diff --git a/configs/imx28_xea_defconfig b/configs/imx28_xea_defconfig index 63ab8349cd..5566945183 100644 --- a/configs/imx28_xea_defconfig +++ b/configs/imx28_xea_defconfig @@ -60,8 +60,6 @@ CONFIG_CMD_REGULATOR=y CONFIG_CMD_EXT4=y CONFIG_CMD_FS_GENERIC=y CONFIG_CMD_MTDPARTS=y -CONFIG_MTDIDS_DEFAULT="nor0=spi3.0" -CONFIG_MTDPARTS_DEFAULT="spi3.0:64k(SPL),448k(uboot),128k(envs),384k(unused1),4096k(kernel),8192k(swupdate),-(unused2)" CONFIG_DOS_PARTITION=y CONFIG_OF_CONTROL=y CONFIG_SPL_OF_CONTROL=y @@ -87,6 +85,7 @@ CONFIG_MXS_GPIO=y CONFIG_SUPPORT_EMMC_BOOT=y CONFIG_MMC_MXS=y CONFIG_MTD=y +CONFIG_DM_MTD=y CONFIG_DM_SPI_FLASH=y CONFIG_SF_DEFAULT_BUS=3 CONFIG_SF_DEFAULT_MODE=0x0 @@ -96,6 +95,7 @@ CONFIG_SPI_FLASH_ISSI=y CONFIG_SPI_FLASH_SPANSION=y CONFIG_SPI_FLASH_STMICRO=y # CONFIG_SPI_FLASH_USE_4K_SECTORS is not set +CONFIG_SPI_FLASH_MTD=y CONFIG_PHYLIB=y CONFIG_PHY_ADDR_ENABLE=y CONFIG_PHY_ADDR=1 diff --git a/include/configs/xea.h b/include/configs/xea.h index 5081cc8691..c3f25b5aa1 100644 --- a/include/configs/xea.h +++ b/include/configs/xea.h @@ -29,10 +29,6 @@ #define CONFIG_SYS_MMCSD_RAW_MODE_ARGS_SECTORS (SZ_32K / 0x200) #define CONFIG_SYS_MMCSD_RAW_MODE_KERNEL_SECTOR (SZ_1M / 0x200)
-#ifndef CONFIG_SPL_BUILD -#define CONFIG_SPI_FLASH_MTD -#endif - /* Memory configuration */ #define PHYS_SDRAM_1 0x40000000 /* Base address */ #define PHYS_SDRAM_1_SIZE 0x10000000 /* Max 256 MB RAM */