-----Original Message----- From: York Sun Sent: Tuesday, November 20, 2018 2:13 AM To: Ashish Kumar ashish.kumar@nxp.com; u-boot@lists.denx.de Cc: Yogesh Narayan Gaur yogeshnarayan.gaur@nxp.com; Rajat Srivastava rajat.srivastava@nxp.com Subject: Re: [PATCH v3] fsl-lsch3: soc: Enable AHB read support for Flexspi controller
On 11/12/18 11:26 PM, Ashish Kumar wrote:
Enable AHB support for Flexspi controller interface meaning memory can be accessed via md command using absolute addresses
Signed-off-by: Yogesh Gaur yogeshnarayan.gaur@nxp.com Signed-off-by: Rajat Srivastava rajat.srivastava@nxp.com Signed-off-by: Ashish Kumar Ashish.Kumar@nxp.com
v3: Depends upon http://patchwork.ozlabs.org/patch/975009/
Hi York,
Sorry that was typo, it was meant to be http://patchwork.ozlabs.org/patch/974301/. But unfortunately after lot of delay in review on NXP-FlexSPI driver, it has been asked to re-write to a new frame-work. I think I should defer this http://patchwork.ozlabs.org/patch/975008/ and http://patchwork.ozlabs.org/patch/996846/ for the time being until 974301 is re-written. What do you suggest?
Regards Ashish
Your v3 patch depends on its v2 version. This doesn't make sense.
York