Use ethernet-phy-id compatible string to properly describe phy reset on kv260 boards. Previous description wasn't correct because reset was done for mdio bus to operate and it was in this case used for different purpose which was eth phy reset. With ethernet-phy-id phy reset happens only for the phy via phy framework.
Signed-off-by: Michal Simek michal.simek@xilinx.com ---
arch/arm/dts/zynqmp-sck-kv-g-revA.dts | 6 ++++-- arch/arm/dts/zynqmp-sck-kv-g-revB.dts | 6 ++++-- 2 files changed, 8 insertions(+), 4 deletions(-)
diff --git a/arch/arm/dts/zynqmp-sck-kv-g-revA.dts b/arch/arm/dts/zynqmp-sck-kv-g-revA.dts index f58ad69be311..9445dace7393 100644 --- a/arch/arm/dts/zynqmp-sck-kv-g-revA.dts +++ b/arch/arm/dts/zynqmp-sck-kv-g-revA.dts @@ -168,16 +168,18 @@ mdio: mdio { #address-cells = <1>; #size-cells = <0>; - reset-gpios = <&gpio 38 GPIO_ACTIVE_LOW>; - reset-delay-us = <2>;
phy0: ethernet-phy@1 { #phy-cells = <1>; reg = <1>; + compatible = "ethernet-phy-id2000.a231"; ti,rx-internal-delay = <DP83867_RGMIIDCTL_2_25_NS>; ti,tx-internal-delay = <DP83867_RGMIIDCTL_2_75_NS>; ti,fifo-depth = <DP83867_PHYCR_FIFO_DEPTH_4_B_NIB>; ti,dp83867-rxctrl-strap-quirk; + reset-assert-us = <100>; + reset-deassert-us = <280>; + reset-gpios = <&gpio 38 GPIO_ACTIVE_LOW>; }; }; }; diff --git a/arch/arm/dts/zynqmp-sck-kv-g-revB.dts b/arch/arm/dts/zynqmp-sck-kv-g-revB.dts index 7236e03a5a74..6ea950a13f45 100644 --- a/arch/arm/dts/zynqmp-sck-kv-g-revB.dts +++ b/arch/arm/dts/zynqmp-sck-kv-g-revB.dts @@ -155,16 +155,18 @@ mdio: mdio { #address-cells = <1>; #size-cells = <0>; - reset-gpios = <&gpio 38 GPIO_ACTIVE_LOW>; - reset-delay-us = <2>;
phy0: ethernet-phy@1 { #phy-cells = <1>; reg = <1>; + compatible = "ethernet-phy-id2000.a231"; ti,rx-internal-delay = <DP83867_RGMIIDCTL_2_25_NS>; ti,tx-internal-delay = <DP83867_RGMIIDCTL_2_75_NS>; ti,fifo-depth = <DP83867_PHYCR_FIFO_DEPTH_4_B_NIB>; ti,dp83867-rxctrl-strap-quirk; + reset-assert-us = <100>; + reset-deassert-us = <280>; + reset-gpios = <&gpio 38 GPIO_ACTIVE_LOW>; }; }; };