Setup bootmode variable based on bootmode selection. This is helping with setting up boot method. Also setup sdbootdevice.
Signed-off-by: Michal Simek michal.simek@xilinx.com ---
board/xilinx/zynqmp/zynqmp.c | 8 ++++++++ 1 file changed, 8 insertions(+)
diff --git a/board/xilinx/zynqmp/zynqmp.c b/board/xilinx/zynqmp/zynqmp.c index 8c859ed8ff8b..7aa9628414fe 100644 --- a/board/xilinx/zynqmp/zynqmp.c +++ b/board/xilinx/zynqmp/zynqmp.c @@ -364,23 +364,28 @@ int board_late_init(void) case USB_MODE: puts("USB_MODE\n"); mode = "usb"; + env_set("modeboot", "usb_dfu_spl"); break; case JTAG_MODE: puts("JTAG_MODE\n"); mode = "pxe dhcp"; + env_set("modeboot", "jtagboot"); break; case QSPI_MODE_24BIT: case QSPI_MODE_32BIT: mode = "qspi0"; puts("QSPI_MODE\n"); + env_set("modeboot", "qspiboot"); break; case EMMC_MODE: puts("EMMC_MODE\n"); mode = "mmc0"; + env_set("modeboot", "emmcboot"); break; case SD_MODE: puts("SD_MODE\n"); mode = "mmc0"; + env_set("modeboot", "sdboot"); break; case SD1_LSHFT_MODE: puts("LVL_SHFT_"); @@ -389,13 +394,16 @@ int board_late_init(void) puts("SD_MODE1\n"); #if defined(CONFIG_ZYNQ_SDHCI0) && defined(CONFIG_ZYNQ_SDHCI1) mode = "mmc1"; + env_set("sdbootdev", "1"); #else mode = "mmc0"; #endif + env_set("modeboot", "sdboot"); break; case NAND_MODE: puts("NAND_MODE\n"); mode = "nand0"; + env_set("modeboot", "nandboot"); break; default: mode = "";