Hi Fabio,
On Mi, 2015-12-23 at 13:42 -0200, Fabio Estevam wrote:
Hi Jörg,
On Mon, Nov 23, 2015 at 4:16 PM, Fabio Estevam festevam@gmail.com wrote:
Hi Jörg ,
On Fri, Nov 20, 2015 at 6:37 PM, Fabio Estevam festevam@gmail.com wrote:
Ok, I will test your proposal below on Monday when I get access to my mx6sxsabresd, thanks.
Your proposal worked fine, thanks. Will send it as a formal patch.
Ethernet on mx6cuboxi is also broken because of 59370f3fcd13508 (""net: phy: delay only if reset handler is registered").
I tried doing:
--- a/board/solidrun/mx6cuboxi/mx6cuboxi.c +++ b/board/solidrun/mx6cuboxi/mx6cuboxi.c @@ -143,7 +143,7 @@ static void setup_iomux_enet(void) SETUP_IOMUX_PADS(enet_pads);
gpio_direction_output(ETH_PHY_RESET, 0); - mdelay(2); + mdelay(10); gpio_set_value(ETH_PHY_RESET, 1); }
,but it did not help.
Any suggestions?
Sorry for the long delay due to christmas vacation.
Do you know which PHY is used on mx6cuboxi?
I am wondering if the ANATOP clock setting is correct (25MHz)?
http://git.denx.de/?p=u-boot.git;a=blob;f=board/solidrun/mx6cuboxi/mx6c uboxi.c;h=fc37f1eef06da5147e5403d4272d220836c9cfbc;hb=HEAD#l167
Does it help to increase the delay and set it to 15ms?
Best regards Jörg Krause