This reverts commit 562f8df18da62ae02c4ace1e530451fe82c3312d.
Note: Even un-reverting this patch couldn't works as expected, based on the latest testing from Heiko Schocher.
Signed-off-by: Jagannadha Sutradharudu Teki jagannadh.teki@gmail.com Cc: Heiko Schocher hs@denx.de --- README | 11 ----------- drivers/mtd/spi/sf_internal.h | 4 ---- drivers/mtd/spi/sf_probe.c | 30 ------------------------------ 3 files changed, 45 deletions(-)
diff --git a/README b/README index fc1fd52..82224f7 100644 --- a/README +++ b/README @@ -3086,17 +3086,6 @@ CBFS (Coreboot Filesystem) support memories can be connected with a given cs line. Currently Xilinx Zynq qspi supports these type of connections.
- CONFIG_SYS_SPI_ST_ENABLE_WP_PIN - enable the W#/Vpp signal to disable writing to the status - register on ST MICRON flashes like the N25Q128. - The status register write enable/disable bit, combined with - the W#/VPP signal provides hardware data protection for the - device as follows: When the enable/disable bit is set to 1, - and the W#/VPP signal is driven LOW, the status register - nonvolatile bits become read-only and the WRITE STATUS REGISTER - operation will not execute. The only way to exit this - hardware-protected mode is to drive W#/VPP HIGH. - - SystemACE Support: CONFIG_SYSTEMACE
diff --git a/drivers/mtd/spi/sf_internal.h b/drivers/mtd/spi/sf_internal.h index 785f7a9..bd834dc 100644 --- a/drivers/mtd/spi/sf_internal.h +++ b/drivers/mtd/spi/sf_internal.h @@ -97,10 +97,6 @@ enum { #define STATUS_QEB_MXIC (1 << 6) #define STATUS_PEC (1 << 7)
-#ifdef CONFIG_SYS_SPI_ST_ENABLE_WP_PIN -#define STATUS_SRWD (1 << 7) /* SR write protect */ -#endif - /* Flash timeout values */ #define SPI_FLASH_PROG_TIMEOUT (2 * CONFIG_SYS_HZ) #define SPI_FLASH_PAGE_ERASE_TIMEOUT (5 * CONFIG_SYS_HZ) diff --git a/drivers/mtd/spi/sf_probe.c b/drivers/mtd/spi/sf_probe.c index 2ee228d..de8d0b7 100644 --- a/drivers/mtd/spi/sf_probe.c +++ b/drivers/mtd/spi/sf_probe.c @@ -288,34 +288,6 @@ int spi_flash_decode_fdt(const void *blob, struct spi_flash *flash) } #endif /* CONFIG_OF_CONTROL */
-#ifdef CONFIG_SYS_SPI_ST_ENABLE_WP_PIN -/* enable the W#/Vpp signal to disable writing to the status register */ -static int spi_enable_wp_pin(struct spi_flash *flash) -{ - u8 status; - int ret; - - ret = spi_flash_cmd_read_status(flash, &status); - if (ret < 0) - return ret; - - ret = spi_flash_cmd_write_status(flash, STATUS_SRWD); - if (ret < 0) - return ret; - - ret = spi_flash_cmd_write_disable(flash); - if (ret < 0) - return ret; - - return 0; -} -#else -static int spi_enable_wp_pin(struct spi_flash *flash) -{ - return 0; -} -#endif - /** * spi_flash_probe_slave() - Probe for a SPI flash device on a bus * @@ -394,8 +366,6 @@ int spi_flash_probe_slave(struct spi_slave *spi, struct spi_flash *flash) puts(" Full access #define CONFIG_SPI_FLASH_BAR\n"); } #endif - if (spi_enable_wp_pin(flash)) - puts("Enable WP pin failed\n");
/* Release spi bus */ spi_release_bus(spi);