Re: [U-Boot] uboot.bin for smdkc100_config fails to boot from NAND

On Wed, Jan 13, 2010 at 03:21:50PM +0530, Naveen Krishna Ch wrote:

Hi All,

I have a SMDKC100 boards with Single chip NAND

Built the mainline uboot for

Das U-Boot# smdkc100_config; make

i use a In-Circuit Debugger to flash the uboot.bin to the NAND.

I checked the dip switches & Jumpers are proper.

The In-Circuit Debugger shows "Emulation running" But, nothing comes up on the UART0

What could be the problem, Any pointers..

Does this chip/board have special hardware/ROM to load a full u-boot image out of NAND into somewhere it can execute?

If not, you'll need nand_spl support for this board.

-Scott