Am 19. November 2024 23:28:36 MEZ schrieb Lothar Rubusch l.rubusch@gmail.com:
Fix some typos and duplicate words in gdb.rst.
Signed-off-by: Lothar Rubusch l.rubusch@gmail.com
doc/develop/gdb.rst | 14 +++++++------- 1 file changed, 7 insertions(+), 7 deletions(-)
diff --git a/doc/develop/gdb.rst b/doc/develop/gdb.rst index 4e359c7f22..dc38435227 100644 --- a/doc/develop/gdb.rst +++ b/doc/develop/gdb.rst @@ -8,12 +8,12 @@ Using a JTAG adapter it is possible to debug a running U-Boot with GDB. A common way is to connect a debug adapter to the JTAG connector of your board, run a GDB server, connect GDB to the GDB server, and use GDB as usual.
-Similarly QEMU can provide a GDB server. +Similarly, QEMU can provide a GDB server.
Preparing build
-Building U-Boot with with reduced optimization (-Og) and without link time +Building U-Boot with reduced optimization (-Og) and without link time optimization is recommended for easier debugging::
CONFIG_CC_OPTIMIZE_FOR_DEBUG=y@@ -24,8 +24,8 @@ Otherwise build, install, and run U-Boot as usual. Using OpenOCD as GDB server
-`OpenOCD https://openocd.org/`_ is an open source tool supporting hardware -debug probes, and providing a GDB server. It is readily available in major Linux +`OpenOCD https://openocd.org/`_ is an open-source tool supporting hardware +debug probes and provide a GDB server. It is readily available in major Linux
Thanks for the patch.
'tool' is singular. You cannot use 'provide' here.
distributions or you can build it from source.
Here is example of starting OpenOCD on Debian using a J-Link adapter and a @@ -124,7 +124,7 @@ with the command *bdinfo*: Early malloc usage: cd8 / 2000
Look out for the line starting with *relocaddr* which has the address -you need, ``0x27f7a000`` in this case. +You need, ``0x27f7a000`` in this case.
You is only capitalized at the start of sentences.
On most architectures (not sandbox, x86, Xtensa) the global data pointer is stored in a fixed register: @@ -144,7 +144,7 @@ riscv gp sh r13 ============ ========
-On these architecture the relocation address cat be determined by +On this architecture the relocation address can be determined by
On these architectures ...
The rest seems correct.
Best regards
Heinrich
dereferencing the global data pointer stored in register, *r9* in the example:
.. code-block:: console @@ -153,7 +153,7 @@ dereferencing the global data pointer stored in register, *r9* in the example: $1 = 0x27f7a000
In the GDB shell discard the previously loaded symbol file and add it once -again with the relocation address like this: +again, with the relocation address like this:
.. code-block:: console