At present the tegra GPIO driver does not fully support the existing device tree binding, but add the binding file to cover the existing partial support.
Signed-off-by: Simon Glass sjg@chromium.org ---
.../gpio/nvidia,tegra20-gpio.txt | 40 ++++++++++++++++++++++ 1 file changed, 40 insertions(+) create mode 100644 doc/device-tree-bindings/gpio/nvidia,tegra20-gpio.txt
diff --git a/doc/device-tree-bindings/gpio/nvidia,tegra20-gpio.txt b/doc/device-tree-bindings/gpio/nvidia,tegra20-gpio.txt new file mode 100644 index 0000000..023c952 --- /dev/null +++ b/doc/device-tree-bindings/gpio/nvidia,tegra20-gpio.txt @@ -0,0 +1,40 @@ +NVIDIA Tegra GPIO controller + +Required properties: +- compatible : "nvidia,tegra<chip>-gpio" +- reg : Physical base address and length of the controller's registers. +- interrupts : The interrupt outputs from the controller. For Tegra20, + there should be 7 interrupts specified, and for Tegra30, there should + be 8 interrupts specified. +- #gpio-cells : Should be two. The first cell is the pin number and the + second cell is used to specify optional parameters: + - bit 0 specifies polarity (0 for normal, 1 for inverted) +- gpio-controller : Marks the device node as a GPIO controller. +- #interrupt-cells : Should be 2. + The first cell is the GPIO number. + The second cell is used to specify flags: + bits[3:0] trigger type and level flags: + 1 = low-to-high edge triggered. + 2 = high-to-low edge triggered. + 4 = active high level-sensitive. + 8 = active low level-sensitive. + Valid combinations are 1, 2, 3, 4, 8. +- interrupt-controller : Marks the device node as an interrupt controller. + +Example: + +gpio: gpio@6000d000 { + compatible = "nvidia,tegra20-gpio"; + reg = < 0x6000d000 0x1000 >; + interrupts = < 0 32 0x04 + 0 33 0x04 + 0 34 0x04 + 0 35 0x04 + 0 55 0x04 + 0 87 0x04 + 0 89 0x04 >; + #gpio-cells = <2>; + gpio-controller; + #interrupt-cells = <2>; + interrupt-controller; +};