On Fri, Sep 14, 2012 at 08:53:32AM -0700, Simon Glass wrote:
Hi,
On Wed, Sep 12, 2012 at 4:42 PM, Marek Vasut marex@denx.de wrote:
Dear Stephen Warren,
On 09/12/2012 04:38 PM, Marek Vasut wrote:
Dear Stephen Warren,
On 09/12/2012 10:19 AM, Tom Warren wrote:
Folks,
Stephen Warren has posted an internal bug regarding the cache alignment 'warnings' seen on Tegra20 boards when accessing MMC. Here's the gist:
Executing "mmc dev 0" still yields cache warnings:
Tegra20 (Harmony) # mmc dev 0 ERROR: v7_dcache_inval_range- stop address is not aligned- 0x3fb69908 mmc0 is current device
...
There have been patches in the past (IIRC) that have tried to ensure all callers (FS, MMC driver, USB driver, etc.) force their buffers to the appropriate alignment, but I don't know that we can ever correct every instance, now or in the future.
Can we start a discussion about what we can do about this warning? Adding an appropriate #ifdef (CONFIG_SYS_NO_CACHE_ALIGNMENT_WARNINGS, etc.) where Stephen put his #if 0's would be one approach, or changing the printf() to a debug(), perhaps. As far as I can tell, these alignment 'errors' don't seem to produce bad data in the transfer.
I don't think simply turning off the warning is the correct approach; I believe they represent real problems that can in fact cause data corruption. I don't believe we have any choice other than to fully solve the root-cause.
Yes I agree, and I think it is pretty close - certainly much better than it used to be. The good thing about them being annoying is that they will likely get fixed :-)
I think I traced this to the copying of CSD a while back. The problem is that the transferred buffer is 8 bytes, so there's no way to make it aligned properly. Unfortunately the entailing discussion did not yield a solution at the time.
Thierry