11 Sep
2008
11 Sep
'08
10:55 p.m.
Dear Matthias Fuchs,
In message 200809111723.54133.matthias.fuchs@esd-electronics.com you wrote:
I noticed some strange CTRL-C behavior in a BSP command. When I run my bsp command interactively everything is fine.
...
But when I call this bsp command as bootcmd CTRL-C does not stop the while loop. So CTRL-C is not detected. Any idea?
Do you happen to have CONFIG_AUTOBOOT_KEYED set in your board configuration?
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd@denx.de
Program maintenance is an entropy-increasing process, and even its
most skilfull execution only delays the subsidence of the system into
unfixable obsolescence. - Fred Brooks, "The Mythical Man Month"