On Tue, Oct 07, 2008 at 06:25:11AM -0500, Nishanth Menon wrote:
Dirk Behme said the following on 10/07/2008 04:42 AM:
It doesn't differ ;)
So I removed this and tried to use default nand_read_buf16() instead:
nand->read_buf = nand_read_buf16;
in board_nand_init(). But this doesn't compile as nand_read_buf16() is static in nand_base.c. How do I use it in OMAP3 NAND driver? Marked it as FIXME in patch.
Probably does not need an explicit initialization, mtd nand_scan should populate that.
Correct, NULL methods will be filled in with defaults if applicable.
+/*
- omap_calculate_ecc - Generate non-inverted ECC bytes.
- Using noninverted ECC can be considered ugly since writing a blank
- page ie. padding will clear the ECC bytes. This is no problem as
- long nobody is trying to write data on the seemingly unused page.
- Reading an erased page will produce an ECC mismatch between
- generated and read ECC bytes that has to be dealt with separately.
Is this a hardware limitation? If so, say so in the comment. If not, why do it this way?
Don't know.
All: Any help?
The issue is simple: assume we read a page of 0xFF's(fresh erased), IF using H/w ECC engine within GPMC, the result of read will be 0x0 while the ECC offsets of the spare area will be 0xFF which will result in an ECC mismatch.
Right, I'd just like to see an explicit statement that this is the only way to do HW ECC that the hardware supports (following verification of that fact, of course), along with a pointer to where in the code the ECC error when reading an empty page is dealt with.
- .eccbytes = 12,
- .eccpos = {
2, 3, 4, 5,6, 7, 8, 9,10, 11, 12, 13},- .oobfree = { {20, 50} } /* don't care */
Bytes 64-69 of a 64-byte OOB are free? What don't we care about?
+static struct nand_ecclayout hw_nand_oob_64 = {
Don't know (or understand?).
All: Any help?
I do not get it either.. ECCPOS is in offset bytes, and oobfree should be {.offset=20,.length=44} /*I always hated struct initialization done as above..*/, but then,
Why not offset 14, length 50?
We need to be able to switch ECC at runtime cause some images have to be written to NAND with HW ECC and some with SW ECC. This depends on what user (reader) of these parts expect.
OMAP3 has a boot ROM which is able to read a second level loader (called x-loader) from NAND and start/execute it. This 2nd level loader has to be written by U-Boot using HW ECC as ROM code does HW ECC to read the image. All other parts, e.g. Linux kernel, use SW ECC as default. For this we have to use SW ECC to write images, then.
Therefore we add an additional user command in cmd_nand.c to switch ECC depending on what user wants to write.
why not use h/w ecc which rom code understands in kernel and u-boot. H/w ecc will be faster in comparison to doing s/w ecc and there is good support in MTD to do it, then there would be no reason for s/w ecc IMHO..
Agreed.
-Scott