On 10/24/24 5:24 PM, Paul Barker wrote:
Micrel KSZ9131 PHY LED behavior is not correct when configured in Individual Mode, LED1 (Activity LED) is in the ON state when there is no-link.
Workaround this by setting bit 9 of register 0x1e after verifying that the LED configuration is Individual Mode.
This issue is described in KSZ9131RNX Silicon Errata DS80000693B [*] and according to that it will not be corrected in a future silicon revision.
[*] https://ww1.microchip.com/downloads/en/DeviceDoc/KSZ9131RNX-Silicon-Errata-a...
Based on commit 0316c7e66bbd in the Linux kernel.
Signed-off-by: Paul Barker paul.barker.ct@bp.renesas.com
drivers/net/phy/micrel_ksz90x1.c | 24 ++++++++++++++++++++++++ 1 file changed, 24 insertions(+)
diff --git a/drivers/net/phy/micrel_ksz90x1.c b/drivers/net/phy/micrel_ksz90x1.c index c48ae6e88f30..4f99b115a3c7 100644 --- a/drivers/net/phy/micrel_ksz90x1.c +++ b/drivers/net/phy/micrel_ksz90x1.c @@ -436,6 +436,26 @@ static int ksz9131_config_rgmii_delay(struct phy_device *phydev) return ret; }
+/* Silicon Errata DS80000693B
- When LEDs are configured in Individual Mode, LED1 is ON in a no-link
- condition. Workaround is to set register 0x1e, bit 9, this way LED1 behaves
- according to the datasheet (off if there is no link).
- */
+static int ksz9131_led_errata(struct phy_device *phydev) +{
- int reg;
- reg = phy_read_mmd(phydev, KSZ9131RN_MMD_COMMON_CTRL_REG, 0);
- if (reg < 0)
return reg;- if (!(reg & BIT(4)))
It would be good to have symbolic names for these BIT()s , please add some #define ... macros .