Hi Fabio,
Subject: Re: [PATCH 10/13] imx: load calibration parameters from fuse for i.MX8MP
Hi Peng and Ye Li,
On Sun, May 3, 2020 at 10:57 AM Peng Fan peng.fan@nxp.com wrote:
From: Ye Li ye.li@nxp.com
i.MX8MP thermal which has two probes and supports temperature range from -40 to 125. The driver still uses default 1p HW calibration at 25C and loads calibration parameters from fuse.
Reviewed-by: Peng Fan peng.fan@nxp.com Signed-off-by: Ye Li ye.li@nxp.com Signed-off-by: Peng Fan peng.fan@nxp.com
Are you able to boot an NXP 5.4.3 kernel on a i.MX8MP EVK board?
5.4.3 upstream kernel + latest upstream uboot?
I am getting a kernel hang right after the serial console is probed: https://eur01.safelinks.protection.outlook.com/?url=https%3A%2F%2Fpasteb in.com%2F3AtvJqWS&data=02%7C01%7Cpeng.fan%40nxp.com%7Cf3d1 e46ad41e4ca90b0608d7ef73f349%7C686ea1d3bc2b4c6fa92cd99c5c301635 %7C0%7C0%7C637241153594873754&sdata=gjGygSnftYVH58eLW%2By 6ZZ4uczLZUM0U0lUk9LQyx5Y%3D&reserved=0
Any suggestions?
I am using ATF from 5.4.3, firmware version is 8.6 and I pass 'export ATF_LOAD_ADDR=0x960000'.
Any ideas?
I am not holiday, not have a board at handle. I will give a try in a few days.
Disable busfreq, try clk_ignore_unused?
Regards, Peng.
Thanks