After the conversion to DM the U-Boot binary is called u-boot-dtb.imx, so fix the README file accordingly.
Signed-off-by: Fabio Estevam festevam@gmail.com --- board/technexion/pico-imx6ul/README | 14 +++++++------- 1 file changed, 7 insertions(+), 7 deletions(-)
diff --git a/board/technexion/pico-imx6ul/README b/board/technexion/pico-imx6ul/README index 1cabd90759..bb8ee3f463 100644 --- a/board/technexion/pico-imx6ul/README +++ b/board/technexion/pico-imx6ul/README @@ -13,7 +13,7 @@ $ make mrproper $ make pico-imx6ul_defconfig $ make
-This generates the SPL and u-boot.img binaries. +This generates the SPL and u-boot-dtb.img binaries.
1. Loading U-Boot via USB Serial Download Protocol
@@ -31,15 +31,15 @@ Connect a USB cable between the OTG pico port and the host PC.
Open a terminal program such as minicom.
-Copy SPL and u-boot.img to the imx_usb_loader folder. +Copy SPL and u-boot-dtb.img to the imx_usb_loader folder.
Load the SPL binary via USB:
$ sudo ./imx_usb SPL
-Load the u-boot.img binary via USB: +Load the u-boot-dtb.img binary via USB:
-$ sudo ./imx_usb u-boot.img +$ sudo ./imx_usb u-boot-dtb.img
Then U-Boot starts and its messages appear in the console program.
@@ -54,11 +54,11 @@ Run the DFU agent so we can flash the new images using dfu-util tool:
=> dfu 0 mmc 0
-Flash SPL and u-boot.img into the eMMC running the following commands on a PC: +Flash SPL and u-boot-dtb.img into the eMMC running the following commands on a PC:
$ sudo dfu-util -D SPL -a spl
-$ sudo dfu-util -D u-boot.img -a u-boot +$ sudo dfu-util -D u-boot-dtb.img -a u-boot
Remove power from the pico board.
@@ -142,7 +142,7 @@ Launch UMS: Flash the new binaries:
$ sudo dd if=SPL of=/dev/sdX bs=1k seek=1; sync -$ sudo dd if=u-boot.img of=/dev/sdX bs=1k seek=69; sync +$ sudo dd if=u-boot-dtb.img of=/dev/sdX bs=1k seek=69; sync
And then SPL binary will load and jump directly to the kernel: