15 Nov
2007
15 Nov
'07
1:03 p.m.
On Thu, 2007-11-15 at 00:47, Tabi Timur wrote:
Timur Tabi wrote:
BTW, where is the code that programs the MAC address *into* the
IDT/SROM? All
we have is code that reads *from* the IDT/SROM. On the 8610, the
MAC address is
stored in I2C EEPROM (address 0x57), and so U-Boot will need to copy
that into
the IDT/SROM *before* this driver runs.
I think I see the problem. The comment in set_mac_addr() is wrong and confused me:
+static void set_mac_addr(struct eth_device *dev) +{
int i;u16 addr;struct uli526x_board_info *db = dev->priv;outl(0x10000, db->ioaddr + DCR0); /* Diagnosis mode *//* Reset dianostic pointer port */outl(0x1c0, db->ioaddr + DCR13);outl(0, db->ioaddr + DCR14); /* Clear reset port */outl(0x10, db->ioaddr + DCR14); /* Reset ID Table pointer */outl(0, db->ioaddr + DCR14); /* Clear reset port */outl(0, db->ioaddr + DCR13); /* Clear CR13 *//* Select ID Table access port */outl(0x1b0, db->ioaddr + DCR13);/* Read MAC address from CR14 */This should say "Write MAC address to CR14"
You are correct! Roy