Hi Stefan,
After booting my target i get the following message..
I2C:ready DRAM:16MB FLASH:2MB In: serial Out:serial Err:serial Net: ppc_4xx_eth0 => and after that if i say => mii info PHY 0x01: OUI = 0x80017, Model = 0x09, Rev = 0x00, 10baseT, HDX => setenv ipaddr 192.168.13.248 => ping 192.168.13.248 After this if i ping it's not pinging self and also the host ip(192.168.13.240). Can you help me out what could be the problem..... => mii read 0x01<PHY Addr> 0x01<register val> when i read the PHY 0x01 register following is the value 0x7849. This value show that "No Link". why so. PHY chip i am using DP83848I
Regards, Shami.
Stefan Roese sr@denx.de wrote: On Wednesday 19 December 2007, shami Allam wrote:
I am working on the 405GP custome board. I am able to bringup the SDRAM,Flash,I2c and serail on the board. But while trying to bringup the ethernet i am getting the following error. "No Ethernet found". On my board there is "DP83848I" PHY chip.
This message gets printed when you don't define the "ethaddr" environement address. So set this variable to a valid value and save the environment and reset the board. Then you should see one eth-interface.
Best regards, Stefan
===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office@denx.de =====================================================================
--------------------------------- Now you can chat without downloading messenger. Click here to know how.
--------------------------------- Save all your chat conversations. Find them online.