Steve,
On 24.06.2016 00:06, Steve Rae wrote:
I am asking you about this code, because of this: commit 29905a4 - mmc: sdhci: Use timer based timeout detection in sdhci_send_command()
Occasionally, I am seeing failures when writing to flash on my device:
Flashing sparse image at offset 2078720 Flashing Sparse Image sdhci_send_command: Timeout for status update! mmc fail to send stop cmd write_sparse_image: Write failed, block #2181088 [0]
I can eliminate this error if I kludge the following code:
diff --git a/drivers/mmc/sdhci.c b/drivers/mmc/sdhci.c index 5c71ab8..854f7ce 100644 --- a/drivers/mmc/sdhci.c +++ b/drivers/mmc/sdhci.c @@ -243,9 +243,9 @@ static int sdhci_send_command(struct mmc *mmc, struct mmc_cmd *cmd, if (stat & SDHCI_INT_ERROR) break; } while (((stat & mask) != mask) &&
(get_timer(start) < CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT));
(get_timer(start) < 600 /*CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT*/));
if (get_timer(start) >= CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT) {
if (get_timer(start) >= 600 /*CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT*/) { if (host->quirks & SDHCI_QUIRK_BROKEN_R1B) return 0; else {I don't know much about this - I arrived at 600 by trial and error (500 fails...) Any ideas?
Perhaps your platform needs a bigger timeout value. Did you check what the Linux driver does here? You could move CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT to Kconfig with a default of 100 and select a higher value for your platform.
Thanks, Stefan