On 11/26/19 10:24 AM, Masahiro Yamada wrote:
On Tue, Nov 26, 2019 at 5:25 PM Marek Vasut marex@denx.de wrote:
On 11/26/19 3:34 AM, Masahiro Yamada wrote:
On Thu, Nov 21, 2019 at 6:37 AM Marek Vasut wrote:
While the Denali NAND is initialized by the BootROM in SPL, there are still a couple of settings which are missing. These can trigger subtle corruption of the data read out of the NAND. Fill these settings in just like they are filled in by the full Denali NAND driver in denali_hw_init().
I'd like to know this in more detailed.
I assume these registers are set up by the BootROM, and SPL is supposed to read data in the same manner as the Boot ROM.
In which situation does the data get corrupted?
When I boot the board, these registers are not set up correctly. The bootrom reads the SPL fine, but the SPL cannot read U-Boot anymore, probably because the bootrom does something funny to the controller settings.
Interesting. The boot ROM can load SPL from a NAND device, but SPL cannot load U-Boot from it in the same manner.
How did you burn SPL, U-Boot proper, respectively? Were they written in different ways?
U-Boot proper, all of it.