when debuging the S3C2416, it could not enter uboot command line, as follows printed information, and then the there will be with no response when the key pressed.
I'm very pleased for your advice! Thank you!
CPU: S3C2416@400MHz mmc0: S Fclk = 800MHz, Hclk = 133MHz, Pclk = 66MHz m Board: SMDK2416 Mobile DDRalising SD card DRAM: 64 MB Flash: 0 kBs3c-sdhci.1: NAND: 512 MBhsmmc (13333333 *** Warning - bad CRC or NAND, using default environment sdhci: card
In: serialion=0 Out: serial s3c-sd Err: serial clock source 1 Not found the DM9000 bs60_init
test
[*]trinityb_init: bs_chip_command(INIT_SYS_RUN)vfat /dev/mmcblk0p1 /mn [*]trinityb_init: bs_chip_wr_reg( 0x0106, 0x0203 ); SDRAM Refresh Clock Configur [*]loa mmcblk0: error -110 tr ationring measure2=7,duration=0 sdh measure2=0,duration=0 [*] [*]set rotate 3 [*]load color bar [*]disp_full(2, 15); [*]bs_cmd_wait_disp_ready() measure2=5,duration=0 measure2=1559,duration=0 nand_read 2200000 trinityb_display_bitmap c0000000 There is no valid bmp file at the given address Hit any key to stop autoboot: 0 SMDK2416 # SMDK2416 # SMDK2416 # SMDK2416 # U-Boot 1.1.6 (Sep 24 2009 - 10:24:40) for SMDK2416 Unknown command 'U-Boot' - try 'help' SMDK2416 # SMDK2416 # SMDK2416 # SMDK2416 # SMDK2416 # SMDK2416 # CPU:3# U-Boot 1.1.6 (Sep 24 2009 - 10:24:40) for SMDK241# CPU :3# U-Boot 1.1.6 (Sep 24 2009 - 10:24:40) for SMDK241# CPU:3# U-Boot 1.1.6 (Sep 24 2009 - 10:24:40) for SMDK241# CPU:3# U-Boot 1.1.6 (Sep 24 2009 - 10:24:40) for SMDK24