Jean-Michel Hautbois wrote:
2009/1/19 Jerry Van Baren gerald.vanbaren@ge.com:
Jean-Michel Hautbois wrote:
[snip]
The error in programming tells that it couldn't write the second byte of the u-boot file. Indeed, I have displayed the memory before and after the prog command, and the first byte is correctly written. I can't understand where my problem is.
Thx and Regards, JM
Hi JM,
Hi Jerry, thx for answering
After you erase the sector/chip, is it all 0xFF (especially the second location)? (I expect it is, but it is good to start with the fundamentals.)
No, it is not. I would say, the first byte is OK (I don't have the board with me right now).
OK, if the chip isn't erased properly, you aren't going to make any headway programming. You have to solve the erase problem first.
Is the block you are trying to erase locked?
If so, I would speculate your flash chip configuration isn't right. You need to know how your hardware is wired:
- How many chips in parallel on the bus?
- Bus width on each chip?
- Bus width into the processor?
The Flash chip is a SIMM with 4 LH28F016SCT chips. When I try to use a 32 bits wide bus, it does not work.
That implies the bus is 32 bits wide made up of 4 x8 chips in parallel. It is possible that it is wired 16 bits wide or 8 bits wide by 2 or 4 chips deep, but that is very unlikely.
Is this a stock Freescale eval board or is it custom h/w?
The config file you sent had: [FLASH] CHIPTYPE I28BX8 ; Flash type CHIPSIZE 0x200000 ; Single chip size (2 Mbyte) BUSWIDTH 8 ; total width for the whole SIMM ;WORKSPACE 0x7e000000 ;workspace in target RAM for fast download FILE u-boot.bin FORMAT BIN 0xFF900000
Searching for the chip type picks up: http://www.datasheetcatalog.org/datasheet/Sharp/mXusvqq.pdf Searching for Abatron flash types picks up: http://www.abatron.ch/fileadmin/user_upload/products/pdf/flashsupp.pdf
OK, looks like you have the right chiptype.
The buswidth most likely needs to be 32. You said you tried this and it didn't work.
Running low on suggestions, but here goes... * Fix the buswidth in the config file and then cycle power on everything to make sure you have a clean new configuration (paranoia sometimes pays off) * Verify the SIMM is x32.
gvb