Hi,
Am using IMX6 processor based board. I am customizing U-boot for my design.
In my board I have NOR Flash which is connected via EIM CS0 port. My question do I have to add any DCD Settings for EIM registers, because IMX6 RM document they mentioned You can use DCD for configuring EIM and MMDC. But they also mentioned " the EIM default settings allow the core to interface to a NOR flash device immediately out of reset. This allows the Chip to interface with any NOR flash device,but has the cost of slow performance"
What they are meaning here "it cost of slow performance"
Can anyone guide me??
Thank,
Balaji S
-
::DISCLAIMER:: -----------------------------------------------------------------------------------------------------------------------
The contents of this e-mail and any attachment(s) are confidential and intended for the named recipient(s) only. It shall not attach any liability on the originator or HCL or its affiliates. Any views or opinions presented in this email are solely those of the author and may not necessarily reflect the opinions of HCL or its affiliates. Any form of reproduction, dissemination, copying, disclosure, modification, distribution and / or publication of this message without the prior written consent of the author of this e-mail is strictly prohibited. If you have received this email in error please delete it and notify the sender immediately. Before opening any mail and attachments please check them for viruses and defect.
-----------------------------------------------------------------------------------------------------------------------