Hi Fabio
On Wed, Jan 24, 2018 at 5:38 PM, Fabio Estevam festevam@gmail.com wrote:
Hi Michael,
[Removed usb list as this is off-topic for them]
On Wed, Jan 24, 2018 at 2:31 PM, Michael Nazzareno Trimarchi michael@amarulasolutions.com wrote:
Can you check where SION bit is mandatory for mx25? I have on IMX51 some PINMUX where sion is enabled. I can clean up a bit the patch to just minimize the change. We have for example:
I think it depends on the pin function per board design, no?
I don't have a pdk and it's difficult to find them so I need to check. Anyway some revision of the firmware on this pendrive are working but the latest one is not working. I have a lot of pen drives and all of them are fully working.
Benoît brings a good point: what is the exact pin that causes the USB failure on your case?
I have tested only with uart and already it does not let it work properly. So I can try to limit in my boot case but I don't think that having SION bit pre-defined it's valid at all. We have a limited number of pin mux with SION enable on any nxp architecture right now for every architecture.
* Benoit * can you test them? I will provide a better changeset let sdcard and some ethernet pin in the right configuation (even ethernet was working without SION enable)
Let's try to understand the exact pin that is causing the problem on your board.
I will check it out. This was an initial patch proposal
Thanks