16 Dec
2010
16 Dec
'10
6:41 p.m.
On 12/15/2010 09:20 AM, Kumar Gala wrote:
From: Li Yang leoli@freescale.com
The current code use all the voltage range support by the host controller to do the validation. This will cause problem when the host supports Low Voltage Range. Change the validation voltage to be based on board setup.
Signed-off-by: Li Yang leoli@freescale.com
Tested-by: Stefano Babic sbabic@denx.de
Regards, Stefano Babic
--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office@denx.de
=====================================================================