On Sun, 10 Apr 2022 00:13:33 -0500 Samuel Holland samuel@sholland.org wrote:
Currently, selecting UART0_PORT_F entirely disables MMC support on sunxi platforms. But this is a bigger hammer then needed. Muxing UART0 to the pins on port F only causes a conflict with MMC0, so minimize the impact by specifically skipping MMC0 init. We can continue to use MMC1/2 if those are enabled.
Let's also remove the preprocessor check while refacting this function.
Signed-off-by: Samuel Holland samuel@sholland.org
Applied to sunxi/master.
Thanks, Andre
board/sunxi/board.c | 22 ++++++++++------------ 1 file changed, 10 insertions(+), 12 deletions(-)
diff --git a/board/sunxi/board.c b/board/sunxi/board.c index 89324159d5..7822001d99 100644 --- a/board/sunxi/board.c +++ b/board/sunxi/board.c @@ -516,19 +516,17 @@ static void mmc_pinmux_setup(int sdc)
int board_mmc_init(struct bd_info *bis) {
- __maybe_unused struct mmc *mmc0, *mmc1;
- mmc_pinmux_setup(CONFIG_MMC_SUNXI_SLOT);
- mmc0 = sunxi_mmc_init(CONFIG_MMC_SUNXI_SLOT);
- if (!mmc0)
return -1;
- if (!IS_ENABLED(CONFIG_UART0_PORT_F)) {
mmc_pinmux_setup(CONFIG_MMC_SUNXI_SLOT);if (!sunxi_mmc_init(CONFIG_MMC_SUNXI_SLOT))return -1;- }
-#if CONFIG_MMC_SUNXI_SLOT_EXTRA != -1
- mmc_pinmux_setup(CONFIG_MMC_SUNXI_SLOT_EXTRA);
- mmc1 = sunxi_mmc_init(CONFIG_MMC_SUNXI_SLOT_EXTRA);
- if (!mmc1)
return -1;-#endif
if (CONFIG_MMC_SUNXI_SLOT_EXTRA != -1) {
mmc_pinmux_setup(CONFIG_MMC_SUNXI_SLOT_EXTRA);if (!sunxi_mmc_init(CONFIG_MMC_SUNXI_SLOT_EXTRA))return -1;}
return 0;
}