On Thu, Apr 21, 2011 at 2:04 AM, Shaohui Xie wrote:
+struct spi_slave *spi_setup_slave(unsigned int bus, unsigned int cs,
- unsigned int max_hz, unsigned int mode)
+{
ccsr_espi_t *espi = (void *)(CONFIG_SYS_MPC85xx_ESPI_ADDR);
you support just one bus ? that's no fun ;).
- /* Enable eSPI interface */
- out_be32(&espi->mode, ESPI_MODE_RXTHR(3)
- | ESPI_MODE_TXTHR(4) | ESPI_MODE_EN);
- out_be32(&espi->event, 0xffffffff); /* Clear all eSPI events */
- out_be32(&espi->mask, 0x00000000); /* Mask all eSPI interrupts */
- /* Init CS mode interface */
- for (i = 0; i < ESPI_MAX_CS_NUM; i++)
- out_be32(&espi->csmode[i], ESPI_CSMODE_INIT_VAL);
- out_be32(&espi->csmode[cs], in_be32(&espi->csmode[cs]) &
- ~(ESPI_CSMODE_PM(0xF) | ESPI_CSMODE_DIV16
- | ESPI_CSMODE_CI_INACTIVEHIGH | ESPI_CSMODE_CP_BEGIN_EDGCLK
- | ESPI_CSMODE_REV_MSB_FIRST | ESPI_CSMODE_LEN(0xF)));
........
usually spi_setup_slave() is to get the slave client ready to be used. it shouldnt be programming any actual hardware registers. that is the point of the spi_claim_bus() and spi_release_bus() steps ... use the information in the slave state to setup the hardware for that slave and then break it down in the release step.
+static u8 cmd_buf[16]; +static size_t cmd_len; +static size_t data_len;
+int spi_xfer(struct spi_slave *slave, unsigned int bitlen, const void *data_out,
- void *data_in, unsigned long flags)
+{
- ccsr_espi_t *espi = (void *)(CONFIG_SYS_MPC85xx_ESPI_ADDR);
- unsigned int tmpdout, tmpdin, event;
- const void *dout = NULL;
- void *din = NULL;
- unsigned int len;
- int numBlks;
- int num_bytes;
- unsigned char *ch;
- unsigned char *buffer;
- size_t buf_len;
- switch (flags) {
- case SPI_XFER_BEGIN:
- cmd_len = bitlen / 8;
- memcpy(cmd_buf, data_out, cmd_len);
- return 0;
interesting solution to the problem, but i'd think it might make more sense to have this state live in the slave data rather than in the global bus.
+void spi_cs_activate(struct spi_slave *slave) +{
- ccsr_espi_t *espi = (void *)(CONFIG_SYS_MPC85xx_ESPI_ADDR);
- unsigned int com = 0;
- com &= ~(ESPI_COM_CS(0x3) | ESPI_COM_TRANLEN(0xFFFF));
- com |= ESPI_COM_CS(slave->cs);
- com |= ESPI_COM_TRANLEN(data_len - 1);
- out_be32(&espi->com, com);
- return;
+}
that return is useless and can be punted -mike