Hi!
MMC boot on the ClearFog (base) still seems to fail (uart boot works fine apart from uart detection). The SPL seems to finish successfully and jump to u-boot but there is no further output then. I'm trying to enable even more `DEBUG` but help is indeed welcome!
Regards
Christoph
================================================================= spl_init()
U-Boot SPL 2016.09-dirty (Oct 02 2016 - 22:04:41) High speed PHY - Version: 2.0 Detected Device ID 6828 board SerDes lanes topology details: | Lane # | Speed | Type | -------------------------------- | 0 | 3 | SATA0 | | 1 | 0 | SGMII1 | | 2 | 5 | PCIe1 | | 3 | 5 | USB3 HOST1 | | 4 | 5 | PCIe2 | | 5 | 0 | SGMII2 | -------------------------------- PCIe, Idx 1: detected no link PCIe, Idx 2: detected no link High speed PHY - Ended Successfully DDR3 Training Sequence - Ver TIP-1.29.0 DDR3 Training Sequence - Switching XBAR Window to FastPath Window DDR3 Training Sequence - Ended Successfully BOOTROM_REG=0xe7001000 boot_device=0xe SAR_REG=0xdb00331e boot_device=0x31
spl:board_init_r()
BOOTROM_REG=0xe7001000 boot_device=0xe SAR_REG=0xdb00331e boot_device=0x31 Trying to boot from MMC1 sdhci_transfer_data: Error detected in status(0x408000)! spl: mmc boot mode: raw hdr read sector 141, count=1 mkimage signature not found - ih_magic = e1a0000d read 190 sectors to 800000 Jumping to U-Boot SPL malloc() used 0x394 bytes (0 KB) loaded - jumping to U-Boot...image entry point: 0x800000