Hi,
I'd like to get edison running in my lab but it has resisted two attempts so far.
My latest problem is that when I try the latest U-Boot, I get:
U-Boot 2020.10-rc3-00012-g9f04a634ef3 (Sep 03 2020 - 07:06:30 -0600)
CPU: Genuine Intel(R) CPU 4000 @ 500MHz DRAM: 980.6 MiB WDT: Started with servicing (60s timeout) MMC: mmc@ff3fc000: 0, mmc@ff3fa000: 1 Loading Environment from MMC... OK In: serial Out: serial Err: serial Net: No ethernet found. Hit any key to stop autoboot: 0 Target:blank Partitioning already done... Flashing already done... Memory layout (mmc) not supported! DFU entities configuration failed! (partition table does not match dfu_alt_info?) dfu - Device Firmware Upgrade
Usage: dfu <USB_controller> [<interface> <dev>] [<timeout>] [list] - device firmware upgrade via <USB_controller> on device <dev>, attached to interface <interface> [<timeout>] - specify inactivity timeout in seconds [list] - list available alt settings
I tried resetting the environment, but then it seems to just clear the environment.
=> env default -a ## Resetting to default environment ## Error: Can't force access to "bootdelay" ## Error: Can't force access to "baudrate"
Then I rebooted and tried the instructions in edison.rst :
run do_force_flash_os Saving Environment to MMC... Writing to MMC(0)... OK Memory layout (mmc) not supported! DFU entities configuration failed! (partition table does not match dfu_alt_info?) dfu - Device Firmware Upgrade
Usage: dfu <USB_controller> [<interface> <dev>] [<timeout>] [list] - device firmware upgrade via <USB_controller> on device <dev>, attached to interface <interface> [<timeout>] - specify inactivity timeout in seconds [list] - list available alt settings
Any ideas please?
Regards, Simon