12 Apr
2019
12 Apr
'19
6:31 p.m.
On Mon, Mar 18, 2019 at 01:54:34PM +0530, Faiz Abbas wrote:
ti_cm_get_macid() is used to get a syscon node from the dt, read the efuse address and then assign the macid read from the address. Divide these two steps into separate functions one of which can be called from ofdata_to_platdata() while the other can be called from _probe(). This ensures that platdata can be assigned statically in a board file when OF_CONTROL is not enabled. Also add a macid_sel_compat in private data to get information about the macid byte placement.
Signed-off-by: Faiz Abbas faiz_abbas@ti.com
Applied to u-boot/master, thanks!
--
Tom