Dear Zeyad A,
Hello,
Please help me to configure u-boot in my NC600 board.
What's this board? Is it supported mainline? What CPU does it have, what version of uboot etc?
I have reached near to u-boot, but the kernel is not booting. After the kernel image upload via serial boot mode it is giving no response.
Kernel or uboot? Maybe your xyzmodem uploader doesn't work with uboot? Minicom worked for me.
If the kernel image upload become complete it is not giving any command line in the u-boot as shown in the guide.
I see ... what terminal emulator do you use to communicate with uboot? btw. uploading via tftp over the ethernet is usually much faster.
The memory is not getting flashed.
Why of course, the loady command downloads data to RAM, you have to flash it via "nand write" or such command afterwards.
It is again booting the same old windows CE in the nand boot mode. Kindly provide me a little support for configuring u-boot.
Thanking you, Regards
Best regards, Marek Vasut