Ulf Samuelson wrote:
There are no Atmel AT91SAM9 dev boards which uses a parallel flash.
This is not quite true. I'm able to boot a AT91SAM9263-EK board via EBI NOR flash and an AT91Bootstrap/Atmel modified U-Boot right now. Did I misunderstand your statement above?
One needs only to solder an appropriate EBI NOR chip to the AT91SAM9263-EK board and install the BMS jumper to allow parallel flash booting. Unfortunately, the boards in the AT91SAM9260-EK and AT91SAM9261-EK can't support an EBI NOR flash due to intentional design limitations.
Sincerely,
Ken Fuchs
-----Original Message----- From: u-boot-users-bounces@lists.sourceforge.net [mailto:u-boot-users-bounces@lists.sourceforge.net] On Behalf Of Ulf Samuelsson Sent: Wednesday, February 13, 2008 15:16 To: E Robertson; u-boot-users@lists.sourceforge.net Subject: Re: [U-Boot-Users] AT91 Bootstrap in U-boot
Hi, Is their a reason why the AT91 Bootstrap code was never ported to U-boot?
Yes, Integrating AT91Bootstrap only makes sense if you have a parallel flash.
There are no Atmel AT91SAM9 dev boards which uses a parallel flash. The AT91RM9200 boards uses parallel flash, but they do not use AT91Bootstrap.
The SAM9 boards all have an AT45 dataflash which has an SPI interface. The BMS pin needs to be configured to make the CPU boot from the internal BootROM. The BootROM copies the initial application at address 0 of the dataflash to internal SRAM. The SRAM can be as small as 4 kB (in the AT91SAM9260) and that limits the functionality. U-Boot does not fit, so you have AT91bootstrap.
AT91bootstrap needs to run BEFORE U-Boot is started.
Best Regards Ulf Samuelsson
This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ U-Boot-Users mailing list U-Boot-Users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/u-boot-users