22 Aug
2012
22 Aug
'12
12:13 p.m.
Hi Tom,
On Wednesday 22 August 2012 03:34 PM, Christian Riesch wrote:
Hi Tom,
On Mon, Aug 20, 2012 at 6:45 PM, Tom Rini trini@ti.com wrote:
- Convert the non-relocation part of board_init_f to spl_board_init, turn on CONFIG_SPL_BOARD_INIT in the configs.
- Remove duplicated code.
- Add spl_boot_device() that returns the statically chosen boot device.
I tested the patchset on the LogicPD AM1808 experimenter's kit:
make da850evm and flashing to SPI flash with mono sfh_OMAP-L138.exe -targetType AM1808 -p /dev/ttyUSB0 -flash_noubl u-boot.ais
I tried testing the same on omap-l138 (the entire patch set) for SPI boot mode itsef, unfortunately the board doesn't even come up. Any Ideas ?
Thx, --Prabhakar
The board boots up fine, but after pressing the reset button or issuing the u-boot "reset" command, it is dead. Only power-cycling helps. Before enabling the SPL framework in this patch reset works fine. Any ideas?
Regards, Christian