Hi Simon,
here is also one small problem if you want to use patman just for one patch then cover letter contains 0/1 but patch itself doesn't contain 1/1.
I think will be good to just add 1/1 to patch too.
Generated by: ./tools/patman/patman -c 1
Thanks, Michal
On 04/24/2013 10:27 AM, Michal Simek wrote:
I want to also write gpio support for Zynq and this driver should be also used for arm zynq.
Currently we have support just for only gpio controller but not for various of them. That's why I would like to get some input from you if possible to add dynamic gpio allocation which could be also helpful for OF support.
Output from my gpio status on Microblaze is below.
Thanks, Michal
U-Boot> gpio status
gpio_info: reset/40000000 (0-0) GPIO_0: reset_pin is an INPUT value = 0
gpio_info: led/40040000 (1-5) GPIO_1: UNKNOWN is an INPUT value = 0 GPIO_2: UNKNOWN is an OUTPUT value = 1 GPIO_3: UNKNOWN is an INPUT value = 0 GPIO_4: UNKNOWN is an INPUT value = 0 GPIO_5: UNKNOWN is an OUTPUT value = 0
Michal Simek (1): gpio: Add support for microblaze xilinx GPIO
arch/microblaze/include/asm/gpio.h | 50 +--- .../xilinx/microblaze-generic/microblaze-generic.c | 17 +- drivers/gpio/Makefile | 1 + drivers/gpio/xilinx_gpio.c | 323 +++++++++++++++++++++ include/configs/microblaze-generic.h | 3 +- 5 files changed, 353 insertions(+), 41 deletions(-) create mode 100644 drivers/gpio/xilinx_gpio.c
-- 1.8.2.1