Set number of lanes and link width speed control register based on the num-lanes property.
Code imported almost 1:1 from dw_pcie_setup in mainline linux.
Signed-off-by: Jonas Karlman jonas@kwiboo.se --- drivers/pci/pcie_dw_rockchip.c | 58 +++++++++++++++++++++++++++++----- 1 file changed, 50 insertions(+), 8 deletions(-)
diff --git a/drivers/pci/pcie_dw_rockchip.c b/drivers/pci/pcie_dw_rockchip.c index 1a35fae5c3a8..bc4635f67136 100644 --- a/drivers/pci/pcie_dw_rockchip.c +++ b/drivers/pci/pcie_dw_rockchip.c @@ -18,6 +18,7 @@ #include <asm/io.h> #include <asm-generic/gpio.h> #include <dm/device_compat.h> +#include <linux/bitfield.h> #include <linux/iopoll.h> #include <linux/delay.h> #include <power/regulator.h> @@ -43,6 +44,7 @@ struct rk_pcie { struct reset_ctl_bulk rsts; struct gpio_desc rst_gpio; u32 gen; + u32 num_lanes; };
/* Parameters for the waiting for iATU enabled routine */ @@ -152,12 +154,13 @@ static inline void rk_pcie_writel_apb(struct rk_pcie *rk_pcie, u32 reg, * rk_pcie_configure() - Configure link capabilities and speed * * @rk_pcie: Pointer to the PCI controller state - * @cap_speed: The capabilities and speed to configure * * Configure the link capabilities and speed in the PCIe root complex. */ -static void rk_pcie_configure(struct rk_pcie *pci, u32 cap_speed) +static void rk_pcie_configure(struct rk_pcie *pci) { + u32 val; + dw_pcie_dbi_write_enable(&pci->dw, true);
/* Disable BAR 0 and BAR 1 */ @@ -167,11 +170,49 @@ static void rk_pcie_configure(struct rk_pcie *pci, u32 cap_speed) PCI_BASE_ADDRESS_1);
clrsetbits_le32(pci->dw.dbi_base + PCIE_LINK_CAPABILITY, - TARGET_LINK_SPEED_MASK, cap_speed); + TARGET_LINK_SPEED_MASK, pci->gen);
clrsetbits_le32(pci->dw.dbi_base + PCIE_LINK_CTL_2, - TARGET_LINK_SPEED_MASK, cap_speed); + TARGET_LINK_SPEED_MASK, pci->gen); + + /* Set the number of lanes */ + val = readl(pci->dw.dbi_base + PCIE_PORT_LINK_CONTROL); + val &= ~PORT_LINK_FAST_LINK_MODE; + val |= PORT_LINK_DLL_LINK_EN; + val &= ~PORT_LINK_MODE_MASK; + switch (pci->num_lanes) { + case 1: + val |= PORT_LINK_MODE_1_LANES; + break; + case 2: + val |= PORT_LINK_MODE_2_LANES; + break; + case 4: + val |= PORT_LINK_MODE_4_LANES; + break; + default: + dev_err(pci->dw.dev, "num-lanes %u: invalid value\n", pci->num_lanes); + goto out; + } + writel(val, pci->dw.dbi_base + PCIE_PORT_LINK_CONTROL); + + /* Set link width speed control register */ + val = readl(pci->dw.dbi_base + PCIE_LINK_WIDTH_SPEED_CONTROL); + val &= ~PORT_LOGIC_LINK_WIDTH_MASK; + switch (pci->num_lanes) { + case 1: + val |= PORT_LOGIC_LINK_WIDTH_1_LANES; + break; + case 2: + val |= PORT_LOGIC_LINK_WIDTH_2_LANES; + break; + case 4: + val |= PORT_LOGIC_LINK_WIDTH_4_LANES; + break; + } + writel(val, pci->dw.dbi_base + PCIE_LINK_WIDTH_SPEED_CONTROL);
+out: dw_pcie_dbi_write_enable(&pci->dw, false); }
@@ -231,11 +272,10 @@ static int is_link_up(struct rk_pcie *priv) * rk_pcie_link_up() - Wait for the link to come up * * @rk_pcie: Pointer to the PCI controller state - * @cap_speed: Desired link speed * * Return: 1 (true) for active line and negetive (false) for no link (timeout) */ -static int rk_pcie_link_up(struct rk_pcie *priv, u32 cap_speed) +static int rk_pcie_link_up(struct rk_pcie *priv) { int retries;
@@ -245,7 +285,7 @@ static int rk_pcie_link_up(struct rk_pcie *priv, u32 cap_speed) }
/* DW pre link configurations */ - rk_pcie_configure(priv, cap_speed); + rk_pcie_configure(priv);
rk_pcie_disable_ltssm(priv); rk_pcie_link_status_clear(priv); @@ -341,7 +381,7 @@ static int rockchip_pcie_init_port(struct udevice *dev) rk_pcie_writel_apb(priv, 0x0, 0xf00040); pcie_dw_setup_host(&priv->dw);
- ret = rk_pcie_link_up(priv, priv->gen); + ret = rk_pcie_link_up(priv); if (ret < 0) goto err_link_up;
@@ -419,6 +459,8 @@ static int rockchip_pcie_parse_dt(struct udevice *dev) priv->gen = dev_read_u32_default(dev, "max-link-speed", LINK_SPEED_GEN_3);
+ priv->num_lanes = dev_read_u32_default(dev, "num-lanes", 1); + return 0;
rockchip_pcie_parse_dt_err_phy_get_by_index: