Hi Marek,
On 07/05/2019 15:05, Marek Vasut wrote:
On 5/7/19 10:43 AM, Neil Armstrong wrote:
This patchset adds support for USB on Amlogic G12A SoCs.
This patchset is composed with :
- PHY Drivers
- USB Control Glue driver
- G12A board setup for Device mode
Device Tree nodes will be added in a separate patchset when applied on a tagged Linux tree.
The Amlogic G12A USB Complex is composed of :
- 2 USB Controllers :
- DWC3 for USB2 and USB3 Host functionality
- DWC2 for USB2 Peripheral functionality
- 2 USB2 OTG PHYs, only a single one will be routed to either DWC2 to DWC3
- 1 USB3 PHY shared with PCIE funcionnality
- A Glue to control PHY routing, setup and OTG detection
The Glue configures the UTMI 8bit interfaces for the USB2 PHYs, including routing of the OTG PHY between the DWC3 and DWC2 controllers, and setups the on-chip OTG mode selection for this PHY.
This drivers supports the on-probe setup of the OTG mode, and manually via a setup function in the G12A common board code.
Changes since v2:
- rebased on u-boot master
Changes since v1:
- switch printf() to debug() in patch 1
Neil Armstrong (3): usb: dwc3: Add Meson G12A USB Glue phy: meson: add Amlogic G12A USB2 and USB3+PCIE PHY drivers mach-meson: g12a: add DWC2 peripheral mode support
arch/arm/include/asm/arch-meson/usb.h | 12 + arch/arm/mach-meson/board-g12a.c | 126 +++++++ drivers/phy/Kconfig | 8 + drivers/phy/Makefile | 1 + drivers/phy/meson-g12a-usb2.c | 216 ++++++++++++ drivers/phy/meson-g12a-usb3-pcie.c | 345 +++++++++++++++++++ drivers/usb/dwc3/Kconfig | 8 + drivers/usb/dwc3/Makefile | 1 + drivers/usb/dwc3/dwc3-meson-g12a.c | 456 ++++++++++++++++++++++++++ 9 files changed, 1173 insertions(+) create mode 100644 arch/arm/include/asm/arch-meson/usb.h create mode 100644 drivers/phy/meson-g12a-usb2.c create mode 100644 drivers/phy/meson-g12a-usb3-pcie.c create mode 100644 drivers/usb/dwc3/dwc3-meson-g12a.c
Looks good to me, pick this via the meson tree please.
No problem, but Lukasz wanted to pick it up.
Lukasz, I can push it through u-boot-amlogic tree, is it ok for you ?
Thanks, Neil