On 03/09/2016 12:22 PM, Rajat Srivastava wrote:
This patch adds a new 'usb regress' command, that can be used to regress test a USB device. It performs the following operations:
- starts the USB device
- performs read/write operations
- stops the USB device
- verifies the contents of read/write operations
Sample Output: => usb regress 81000000 82000000 32m regressing USB.. starting USB... USB0: Register 200017f NbrPorts 2 Starting the controller USB XHCI 1.00 scanning bus 0 for devices... 2 USB Device(s) found scanning usb for storage devices... 1 Storage Device(s) found USB write: device 0 block # 0, count 65536 ... 65536 blocks write: OK USB read: device 0 block # 0, count 65536 ... 65536 blocks read: OK stopping USB.. verifying data on addresses 0x81000000 and 0x82000000 Total of 65536 word(s) were the same
Signed-off-by: Rajat Srivastava rajat.srivastava@nxp.com Signed-off-by: Rajesh Bhagat rajesh.bhagat@nxp.com
Does it do anything which cannot be achieved on the command line itself using "usb reset" "usb write" "usb read" "cmp" commands ?