Resort code to use priv->phydev variable directly. It will simplify move to DM.
Signed-off-by: Michal Simek michal.simek@xilinx.com ---
Changes in v3: None Changes in v2: None
drivers/net/zynq_gem.c | 23 ++++++++++------------- 1 file changed, 10 insertions(+), 13 deletions(-)
diff --git a/drivers/net/zynq_gem.c b/drivers/net/zynq_gem.c index 65ea5deb23c6..8f3fe9130066 100644 --- a/drivers/net/zynq_gem.c +++ b/drivers/net/zynq_gem.c @@ -315,7 +315,6 @@ static int zynq_gem_init(struct eth_device *dev, bd_t * bis) u32 i; int ret; unsigned long clk_rate = 0; - struct phy_device *phydev; struct zynq_gem_regs *regs = (struct zynq_gem_regs *)dev->iobase; struct zynq_gem_priv *priv = dev->priv; struct emac_bd *dummy_tx_bd = &priv->tx_bd[TX_FREE_DESC]; @@ -394,23 +393,21 @@ static int zynq_gem_init(struct eth_device *dev, bd_t * bis) return ret; }
- /* interface - look at tsec */ - phydev = phy_connect(priv->bus, priv->phyaddr, dev, - priv->interface); + priv->phydev = phy_connect(priv->bus, priv->phyaddr, dev, + priv->interface);
- phydev->supported = supported | ADVERTISED_Pause | - ADVERTISED_Asym_Pause; - phydev->advertising = phydev->supported; - priv->phydev = phydev; - phy_config(phydev); - phy_startup(phydev); + priv->phydev->supported = supported | ADVERTISED_Pause | + ADVERTISED_Asym_Pause; + priv->phydev->advertising = priv->phydev->supported; + phy_config(priv->phydev); + phy_startup(priv->phydev);
- if (!phydev->link) { - printf("%s: No link.\n", phydev->dev->name); + if (!priv->phydev->link) { + printf("%s: No link.\n", priv->phydev->dev->name); return -1; }
- switch (phydev->speed) { + switch (priv->phydev->speed) { case SPEED_1000: writel(ZYNQ_GEM_NWCFG_INIT | ZYNQ_GEM_NWCFG_SPEED1000, ®s->nwcfg);